PAGE UPDATED 15.4.2010

A4000D MOTHEBOARD INSULATION PLASTIC MARKING

When A4000 motheboard is removed from its case. Sometimes the insulation plastic between the motheboard and the case may accidentally turn upside down. This will not only compromise the insulation but also it will lift the motherboard too high to fit  because the insulation plastic will get pinned over the screw attachment points and under the motheboard.

Requirements:
Instructions:

Unscrew and remove A4000 motherboard

Locate big metallic X in the middle of the A4000D

First mark X in the middle of the insulation plastic, then lift the insulation plastic and mark  X under it in the middle of the big metallic X.

Put them back and it should look like this.


Also screw attachment points are pretty perfectly aligned with the holes in the insulation plastic.


Move the insulation plastic carefully sideways and if marking was made correctly, then two marker pen X should appear like this.


If the insulation plastic is put upside down, there will be two X far away from each other and all the holes are not aligned all the screw attachment points.


Another way to place the plastic incorrectly (side holes adjusted, but middle holes not adjusted).


BACK TO MAIN PAGE